: | Jan 17, 2005 |
. |
Raise and support the vehicle. |
. | Remove the wheel and tire. |
. |
Remove the brake tube.
|
. | Disconnect the height sensor link arm. |
. | Release the wheel speed sensor lead. ![]() |
. | RH side only: Release the brake pad wear
indicator sensor lead. ![]() |
. | Remove the upper arm.
![]() |
. | Install the upper arm.
|
. | Set the height between the center of the
halfshaft end and the edge of the fender trim to 485 mm (19.10'').
![]() |
. |
Connect the upper arm and wheel knuckle.
|
. | Tighten the upper arm front bolt to 175 Nm (129 lb.ft). |
. | Tighten the upper arm rear bolt to 275 Nm (203 lb.ft). |
. | Secure the wheel speed sensor lead. |
. | Secure the brake pad wear indicator sensor lead. |
. | Connect the height sensor link arm. |
. | Install the brake tube.
|
. | Bleed the brake system. |
. | Install the wheel and tire.
|
. | Carry out the wheel alignment procedure. |